Bf 109 "Afrika" - PLUS - stencils & markings

Bf 109 "Afrika" - PLUS - stencils & markings for the Eduard kit

The set contains:

1x Messerschmitt Bf109 "Afrika" - Markings 1/48 - 248050

2x Messerschmitt Bf 109F - Stencils 1/48 - 248045

2x Bf109 G-K - Stencils 1/48 - 248030

The biggest issue relating to using ordinary decals is the varnish which creates a glossy film around the decal. It is quite hard to work with classic decals the way to make this film invisible and it is impossible to reach a good result in case of metallic surfaces. OK, there are dry transfers on the market but work with them is also quite uncomfortable, it is hard to place them correctly and a modeler has the one chance only.

HGW's wet transfers are similar to ordinary decals. It is possible to move them during the attaching process and find the best position. Then just push the water from below the transfer, let it dry few hours, remove the transfer foil and work is done. Only text or symbol stays attached to the surface.

Instructions:

1. Cut the required part.
2. Soak in hot water and wait till the decal loose its base-paper.
3. Apply as regular decal.
4. Push the water from below the decal.
5. Let it dry for 2-3 hours.
6. Remove the transfer foil and clean the glue stains with water.

By HGW Models